User manual

www.merging.com/hapi Page 52
Hapi User Manual
Network Menu (Setup)
Device Name: Name of the Hapi unit. This name will be broadcast across the network and will
be seen in applications such as the MT Discovery tool. The Hapi unit name can
be changed from the Web control access Network page (see section below for
all details)
IP Settings: Manual: Type IP address using box selection and the - or + buttons
Auto: The IP address will be automatically attributed using ZeroConf/Auto-IP
mechanism (address range 169.254.xx.xx if no DHCP server is present)
Address: Set the IP Address for the Hapi unit by using box selection and the - or +
buttons (Available only with IP Settings = Manual)
Netmask: Set the Subnet Mask for the Hapi unit by using box selection and the < or >
buttons (Available only with IP Settings = Manual)
Apply & Reboot: Once changes have been made to this section, you must press this button to
save the settings and power cycle the Hapi unit
Note:
Hapi has no DHCP-server capability neither does the Merging PCIe Ethernet
Controller Card NET-MSC-GBEX1.
By default the Hapi IP setting is set to “Auto” configuration mode which gives
an address in the range 169.254.xxx.xxx if no DHCP server is present on the
network. Users are free to put a DHCP server in their RAVENNA network with
a customized address range and the Hapi would get an IP address from this
server. Note that our recommended Dell PowerConnect 2816 RAVENNA
switch is configured with DHCP disabled.
Merging recommend the Hapi to be configured in “Auto” mode and the Merging
PCIe Ethernet Controller Card NET-MSC-GBEX1 to also be configured with
“Internet Protocol Version 4” with “Obtain an IP automatically”.
You must be aware that when the Hapi is started in Maintenance mode the IP
configuration is exclusively done using “Auto” IP settings mode.
Info (Setup):
In this sub menu you will find details about the Hapi internals; current consumption, voltage,
temperature, fan speed, serial number and the firmware version currently installed.