User manual

www.merging.com/hapi Page 51
Hapi User Manual
System (Setup):
ASIO Clock: If set to Auto enabled: The ASIO clock will be generated by the Hapi which will
be PTP Master.
If Auto is disabled: The ASIO clock will always be generated by this Hapi.
Note: Do not disable unless you are sure that no Hapi will be PTP Master.
Home Page: Users can decide what will be their Hapi OLED Home Page. You can return to
the Home Page by performing a long Rotary Control push or by pressing the
Hapi front panel Home Page button (small Pyramid). Users can also set a
Home page display delay option of; 15 seconds, 30 seconds, 1 minute or set it
to Never (disabled).
A/D Metering: The screensaver redirects you to the AD Meters Page.
D/A Metering: The screensaver redirects you to the DA Meters Page.
In Levels: The screensaver redirects you to the Input Level Page.
Out Levels: The screensaver redirects you to the Output Level Page.
Volume: The screensaver redirects you to the Volume Page.
Long push the Rotary Control to exit those pages.
Screensaver: The Hapi screen will turn black after a 30min delay wihout user
interaction. This is in order to preserve the life span of the Hapi OLED display.
To exit the Screensaver press the Rotary Control Button or quickly press the
Hapi Home Page button or Power button (Hapi front panel pyramids button).
Latency: The Hapi has 4 Latency Settings (in samples) that will determine the device
latency over a RAVENNA network. When multiple RAVENNA devices (e.g.
Horus & Hapi) are connected over a network, they adjust themselves to the
lowest latency that can globally be achieved.
- Ultra Low (16 smp)
- Extra Low (32 smp)
- AES 67 (48 smp)
- Low (64 smp)
Terminations: 75Ω for WCK: Sets 75Ω termination for the Wordclock Input. Enabling this will
disable the Wordclock output.
75Ω for Video: Sets 75Ω termination for the Video reference Input. Unless the
Video Reference signal provided to the Hapi is daisy-chained to other
equipment, you should always terminate your Video signal for most reliable
operation.
Badge: Dim active will darken the Hapi display luminosity. When active this saves
some power and hence some internally generated heat.