User manual

www.merging.com/hapi Page 49
Hapi User Manual
Note: Mykerinos users who are connected to the Hapi should configure their
Mykerinos Pyramix general settings so that the MADI High Speed mode is
disabled and then set the Hapi to 48k Frame (legacy).
Modules: A/D Sub-Menu
Mic Alignment: User can offset the Mic Gain Alignment scaling from a Range of 0dB to +12dB.
Example: Setting a gain alignment of +10dB will make the Hapi, Web Access
or the Pyramix PreAmps control to be offset by a scaling of +10 dB.
Serial Number: This is the place you can access all your Modules serial numbers without
having to unslot them or open the box
Type: Module Type description (Example : Premium Direct Out)
Modules: D/A Sub-Menu
Output attenuation: Calibration of the D/A output (Range -60.0 dB to 0 dB).
Refer to the Hardware section for the D/A onboard output level calibration.
Roll Off Filter: Sharp roll-off filter: Offers a flat frequency response up to 22kHz, within 0.2dB,
which has the tradeoff of 36 samples latency. This mode was and still is the
default one.
Slow roll-off filter: Offers a low latency of 9 samples, with the tradeoff of a
gentle frequency response attenuation starting around 16kHz and reaching -
2.5dB at 22kHz
Serial Number: Module serial numbers
Type: Module Type description