User manual

www.merging.com/hapi Page 40
Hapi User Manual
Meters Settings Menu
Hot: Sets the level above which the meter display will be red. If set to 0dB this will
mean clipping. Range -2dBFS to 0dBFS
Alignment: Sets metering level alignment range (yellow leds). Range -24dBFS to 0dB
Decay integration time: Sets the rate at which the level meter display decays after the level falls below
the most recent Peak.
Peak Hold: If ON it will keep the red Peak Hold Overload in display
I/O Menu
Sync Sub-Menu (I/O)
The IO and Synchronization menu is where the user can select the source of the Hapi reference clock.
It is essential that these settings are configured correctly in order to ensure a clean audio signal through
the Hapi unit.
Reference Source Choose the desired sync source by selecting a Reference source.
Available Reference Sources are: RAVENNA, WordClock, MADI, AES or
SPDIF
Reference navigation Selecting a Reference with multiple choices (such as Sync or AES) will enable
the source navigation. The navigation is performed from top to bottom and will
cycle through in this order at each consecutive press. The selection of another
Reference Source will re-select the top entry in the list by default.