User manual

www.merging.com/hapi Page 35
Hapi User Manual
The selection of the mode can be done using jumper J13 on the backplane of Hapi.
Jumper J13 pinout:
- 1-2: normal operation
- 2-3: always ON operation
The default ex-factory setting is normal mode
Turn ON your Hapi
1. Press the Hapi Front Panel Power Button
Note: Pressing the power button while also pressing down the small triangle Home Page button will
start up in Maintenance Mode, such mode is necessary for firmware updates only.
2. The Hapi front panel button will turn on. If the panel button light isn’t steady but appears to flicker,
this may indicate a fault condition and requires immediate shut down.
3. Wait until the Hapi is fully started and displaying the Main Home screen.