User manual

www.merging.com/hapi Page 28
Hapi User Manual
Installing an additional Hapi I/O Module
Installing additional Hapi I/O Cards (AD8/AD8P or DA8/DA8P)
Before you start
- Place the Hapi unit on a hard, dry surface or mount it onto a 19” rack and leave plenty of room
for air convection.
- In order to meet the EMC requirements of directives 89/336/EEC and 93/68/EEC, and in order
to obtain the high performance possible for the Hapi unit, you must use correctly shielded
cables of good quality for all external connections when installing the Hapi unit. For the power
connection, a normal unshielded power cable with a proper ground can be used.
- Make sure that your sound system is at a safe volume level.
Hardware Installation
This section will take you through installation of your Hapi unit. We will describe how to mount the I/O
modules and the power, audio and digital cable connections that can be accessed on the rear panel.
*PLEASE ENSURE THAT YOUR HAPI UNIT IS SWITCHED OFF BEFORE ATTEMPTING TO
CONNECT ANY CABLES TO THE UNIT.*
If you need to mount an I/O module at a later stage, the following procedure is used.
1. Place the shutdown Hapi unit on a dry steady horizontal surface. Remove all cables (including
the power cable).
2. On the back of the Hapi unit there are 2 slots for mounting the Analog I/O cards or a MADI
card.
3. To remove blind plates from I/O module slots, remove the 2 screws on either side of the plate.
Use a Phillips (cruciform) screwdriver tool size 2
4. Only remove the number of blind plates necessary to fit the I/O module(s). If only one I/O slot is
installed, remove only 1 blind plate. If 2 I/O slots are installed, remove 2 blind plates.
5. It is very important to insert the I/O card horizontally and carefully into the Hapi unit. There are 6
set of guides inside the Hapi unit to guide the I/O cards correctly into place. Do not use force in
any way to insert the I/O card. This may damage the card. Slide card slowly as picture below
shows.
6. When the cover plate of the I/O card covers the hole created by removing the blind plate, the 2
screws from the blind plate are mounted in the sides of the I/O card. Tighten the screws
carefully and be careful not to damage the threads.
7. After inserting the I/O module, the Hapi unit might need to be initialized. If this is the case,
please follow the instructions received with the I/O module.