User manual

www.merging.com/horus Page 7 - 9
Horus Release Notes
 Fixed. Larger Wordclock range of deviation allowing some highly deviating clock sources
(more than 100 ppm) to lock correctly
 Fixed. RAVENNA small mute on random streams
 Fixed. Some Horus were always rebooting in Maintenance Mode or hanging on “starting
application” screen
 Fixed. Limit preamp fader moves to the group min and max for all members of the group
 Fixed. Horus being muted at times (needing extra reboot).
Fixed in Firmware version 433*:
 *To upgrade to this firmware version and the ones above it is mandatory to first update your
Maintenance Mode to v23
Note: Users will have to manually shutdown their Horus after the maintenance mode
successful install, as Horus will most probably not shutdown by itself that time only.
 Improvement:: Added Sample Rate in I/O&Sync page (both TFT and WebApp)
 Improvement: Better communication with analog modules
 Improvement: Added preset page (support for 5 presets Save/Load)
 Improvement: New Auto-Save configuration option in Preset Page
 Improvements on RAVENNA audio streams (clicks removed)
 Improvements on external synchronization (devices with large deviation are supported i.e.
RME and TC Electronics).
 Fixed: Screensaver disable touch can no longer affect the TFT button in the behind display
 Fixed: TFT + and – buttons now have pressing highlight state.
 Fixed. Horus: PreAmps, first gain increment can increase by +5dB instead of +0.5dB
 Fixed. PTP Slave sync locking robustness
 Fixed: Negative delta reference potential freeze
 Fixed. Missing UI update in TFT I/O&Sync page setting change
 Fixed: DA module, no more clicks when changing sampling rate
 Fixed: Web Access added confirmation pop up for reboot or shutdown confirmation
 Fixed: Module missing after firmware update.
 Fixed: Fan stopping issue at sampling rate change
 Fixed: RAVENNA stream address conflicts
Fixed in Firmware version 323*:
 *To upgrade to this version and the ones above it is mandatory to first update your
Maintenance Mode to v10
Note: In such case a message “Wrong maintenance version, must be >= 10” will be displayed
Once the Maintenance mode updated you will be able to install firmware’s >= v323
 Fixed: Bug on the Legacy mode the MADI input
 Fixed: Bug on the DA page web access
 Fixed: Mute correctly done when no signal on the input
 Fixed: Improved connections in RAVENNA mode when multiple connections are active
 Fixed: Improved MTDiscovery Horus entry display and detection
 Fixed: Horus Web Access : D/A Page visible to RAVENNA selection not working from Web
access
Fixed in Firmware version 296:
 Improvements: WordClock and AES input sync support
 Fixed. Horus: PreAmps trim dB value not updated if clicking next to slider to increase the gain
 Fixed: MADI I/O now compatible with RME devices that apparently do not conform entirely to
MADI standard (AES10-2008, section 4.3.2) and were rejecting Horus output due to some
RME’s own restrictions.
 Fixed: Improvements on Wordclock lock (at multiples of FS)
 Fixed. Correction on the AES input at 176.4 kHz
 Fixed. MADI auto switch to Extended mode when nFS is > 1
Fixed in Firmware version 287:
 Fixed: MADI signal level too high
 Fixed: Connection issue with RAVENNA
Fixed in Firmware version 280:
 Fixed: Corrupted noise in RAVENNA at 2FS and higher