Horus Release Notes Horus & Hapi Release Notes www.merging.
Horus Release Notes HORUS & HAPI FIRMWARE Make sure that you are running the latest certified firmware: http://www.merging.com/products/horus/downloads Verify your Horus or Hapi firmware version by going to the Horus or Hapi Setup menu and open the System info page to verify the firmware version installed. Refer to the Horus or Hapi User Manual Firmware Update section in order to proceed with a Firmware update. Note: There are two types of Horus & Hapi updates possible.
Horus Release Notes Fixed. “Product type does not match” firmware update error Fixed in Firmware version 23877: *To upgrade to this firmware version and the ones above it is mandatory to first update your Maintenance Mode to v29 New: First Hapi firmware support Improvement: Firmware extension renamed: Horus firmware is a .horus and Hapi a .hapi file Improvement: LTC discontinuity when locked to external source Improvement. Avoid Horus blank boot TFT screen (maintenance mode 29>) Fixed.
Horus Release Notes Fixed. Potential “Application Failed” error at Horus launch or Ravenna reconnection Fixed in Firmware version 21673: For Horus DXD & DSD support in RAVENNA. The Pyramix users must upgrade to Pyramix v8.1 Improvement: AD8D clarified 4FS limitation Improvement: Fixed digital wrap near fullscale in DSD64 Fixed in Firmware version 21289: For Horus DXD & DSD support in RAVENNA. The Pyramix users must upgrade to Pyramix v8.
Horus Release Notes Fixed in Firmware version 19243: Improvement: Added MADI “96k Frame” Option (High Speed) for MADI output. This option is only available at 88.2/96kHz sampling rate. Fixed. Web Access, MADI extension 2 not visible in routing Fixed in Firmware version 18935: Fixed. Module serial number not readable from Horus TFT Fixed. RAVENNA i/o could end up muted due to video sync reference changes Fixed.
Horus Release Notes Fixed in Firmware version 18725: Warning: Users updating from a firmware < 18491 (RC1) will need to perform a second Shutdown of the Horus after the Firmware update (in order to initialize correctly the AD and DA modules) Improvement: Metering support on the Web Access Page (see Horus user manual for details) Improvement: The Horus TFT Meter page will gray out all inactive MADI leds Improvement: WordClock output now supported at all sampling rates Improvement: Lock mechanism imp
Horus Release Notes Fixed. Larger Wordclock range of deviation allowing some highly deviating clock sources (more than 100 ppm) to lock correctly Fixed. RAVENNA small mute on random streams Fixed. Some Horus were always rebooting in Maintenance Mode or hanging on “starting application” screen Fixed. Limit preamp fader moves to the group min and max for all members of the group Fixed. Horus being muted at times (needing extra reboot).
Horus Release Notes Fixed: WordClock support with phase alignment Fixed: The D/A Small fade in apply on source is now removed Fixed: TFT splashscreen option (Setup>Advanced) Fixed: Web Control access: PreAmps Metering range for Mics and Line Fixed: Web Control access: PreAmps Mic Pading range indication Fixed: Web Control access: PreAmps Mic/Line Coherency and relative group Gains support Fixed: Web Control access: Horus User Manual embedded (now working with Chrome) Fixed in Firmware versi
Horus Release Notes HORUS & HAPI TROUBLESHOOTING Rollback Firmware Users that need to rollback to a previous firmware version can do so. Firmware v23783 goes with Maintenance Mode v29 and does not support Maintenance Mode v23. Firmware v23165 and below go with Maintenance Mode v23 or Maintenance Mode v29 Note: What might occur if your Firmware version is not in front of the Maintenance Mode version is that the Horus might always start up in Maintenance mode.
