User manual

Monitoring Outputs

MONITOR OUTPUTS

LEFT RIGHT

PHONES

VOLUME

Any professional level balanced audio input can be connected to the analog line monitor outputs of the DUA II.

4 output levels are selectable from consumer level (–10 dBV) up to professional level (+4 dBu).

See chapter 4 on how to configure the Analog Outputs Level.

The monitor outputs are also available on a stereo ¼ inch Jack connector with the volume control for a headphone.

Note: The volume control only impacts on the headphone monitoring, not on the XLR line outputs.

Power Switch & Remote indicator

REMOTE

POWER

The POWER switch toggles the power source on and off.

The REMOTE LED type indicator indicates whether the DUA II unit is in remote or local control.

It displays also an error status:

- If the LED is not lit, the DUA II is ready in local control mode.

- If the LED is lit on GREEN, the DUA II is ready in remote control. In this mode, the DUA II front panel controls

are being controlled via a software application (such as the Merging Pyramix Workstation).

- If the LED is lit on RED, the DUA II is not ready. The LED lights on RED at power-up for less than 1 second.

If the LED still light on RED ~1 second after power up, it means that DUA II is not working properly.