Installation Guide

English

LED Explanation

(For Range Extender Mode)

O Power is o.

Blinking

The extender is starting or connecting to the

host network.

Solid Red

The extender is not connected to the host

network.

Solid Green

The extender is connected to the host network

and works well.

Solid Orange

The extender is connected to the host network,

but is too far away from the router.

FAQ (Frequently Asked Questions)

Q1 How do I configure the extender using WPS?

• Plug the extender into a power outlet near your router, and wait

until the Signal LED is lit and solid red.

• Press the WPS button on your router.

• Within 2 minutes, press the WPS or RESET/WPS button on the

extender. The LED should change from blinking to a solid state,

indicating a successful WPS connection.

Q2 How do I reset the extender?

• With the extender powered on, press and hold the Reset

or RESET/WPS button until the Signal LED turns off, then

release the button. When the Signal LED turns solid on, the

reset process is complete.

Q3 What should I do if I cannot access the extender’s web

management page?

• Make sure your wireless device is connected to the

extended network using the extended SSID.

• Verify that http://mwlogin.net is correctly entered in the web

browser.

• If you are using a computer, make sure it is set to obtain an

IP address automatically.

• Refer to Q2 to reset the extender and try again.