Owner`s manual

SC 1000 SPEEDOMETER
36 eng
External Sensors
(SAVE) ( YES )
CALIBRATION
EXTERNAL SENSORS
( NO )
USE GPS SPEED ? YES
52684
Use the GPS input to drive the speed
display? Press "–" to select "NO" or "+" to
select "YES".
(SAVE) ( UP )
23592
CALIBRATION
SEA TEMP
(DOWN)
OFFSET = 0 F
Adjust the seawater temperature sensor to
correct display readings that are too high/low.
Press "–" or "+" to calibrate the temperature
display "DOWN" or "UP".
DISPLAY UNITS
1. Press the "MODE/SELECT" and "+" buttons simultaneously
for approximately seven seconds until "SCREENS" is
display screen.
2. Press "MODE/SELECT" to advance through the selections
to the exit screen and press the "+" button.
3. Press the "MODE/SELECT" to advance to the display units.
Display Units
23540
SPEED UNITS
MPH
[DOWN]
[SAVE]
[ UP ]
Changes the units in which speed is
displayed. Choose from: MPH (Miles Per
Hour), KN (Knots), or KMH (Kilometers Per
Hour).
[DOWN]
[SAVE]
[ UP ]
23539
DISPLAY UNITS
ENGLISH
Changes units of measurement between
English or metric. Select "DOWN" or "UP" to
change between English or metric units.
Simulator Mode
Refer to Simulator Mode.
[ NO ] [ YES ] [SCREENS]
CALIBRATION
EXIT ?
52691
Select "NO" to go through the calibrations
again, "YES" to exit, or "SCREENS" to go
through the screens selection.
SIMULATOR MODE
NOTE: Simulator mode can only be use when the gauge is not
connected to a power package and is used for visual display
purposes.