Owner`s manual

SC 1000 SPEEDOMETER
eng 35
Fuel Used
[DOWN]
[SAVE] [ UP ]
FUEL USED CAL :
AMOUNT
REFUELED = 0.0 G
30168
Adjusts fuel used calibration using the amount
of fuel replaced. Press "–" to select "DOWN,"
or "+" to select "UP."
The fuel option functions the same as the
multiplier. If the gauge indicates that 10
gallons of fuel was used, but the actual fuel
that was added is 14 gallons, change the
amount refueled to 14.0. If the gauge
indicates that 10 gallons of fuel was used, but
the actual fuel that was added is only 8
gallons, change the amount refueled to 8.0
gallons. The gauge will calculate the multiplier
and will automatically change the number in
the multiplier option.
CALIBRATION–EXTERNAL SENSORS
1. Press the "MODE/SELECT" and "+" buttons simultaneously
for approximately seven seconds until "SCREENS" is
display screen.
2. Press "MODE/SELECT" to advance through the selections
to the exit screen and press the "+" button.
3. Press the "MODE/SELECT" to advance to Calibration–
External Sensors.
External Sensors
(SKIP) (EDIT)
CALIBRATION
EXTERNAL SENSORS
52681
Selects and calibrates external sensors that
are installed in the system. Select "SKIP" to
proceed to the next selection. Select "EDIT"
to proceed to external sensor selection.
(SAVE) ( YES )
CALIBRATION
EXTERNAL SENSORS
( NO )
AIRTEMP ? YES
52682
Is an air temperature sensor installed? Press
"–" to select "NO" or "+" to select "YES".
(SAVE) ( YES )
CALIBRATION
EXTERNAL SENSORS
( NO )
GPS ?
YES
52683
Is a GPS sensor installed? Press "–" to select
"NO" or "+" to select "YES".