Owner`s manual

SC 1000 SPEEDOMETER
34 eng
Speedometer Display Screens
[ NO ] [ YES ] [CAL ]
SCREENS
EXIT ?
52646
Select "NO" to go through the screen
selection again, "YES" to exit the screens, or
"CAL" to calibrate the tank levels. Refer to
Calibration–Fuel Used.
CALIBRATION–FUEL USED
1. Press the "MODE/SELECT" and "+" buttons simultaneously
for approximately seven seconds until "SCREENS" is
display screen.
2. Press "MODE/SELECT" to advance through the screen
selections to the exit screen and press the "+" button to
enter Calibration–Fuel Used.
Fuel Used
(SKIP) (EDIT)
CALIBRATION
FUEL USED
52687
Selects how fuel used is calibrated. Press "+"
to select "EDIT" or "SELECT" to bypass how
the fuel used is calibrated.
[FUEL]
FUEL USED CAL :
ENTER MULTIPLIER,
OR REFUELED ?
[MULT]
30166
Selects how fuel used is calibrated with a
multiplier or with refueling. Press "–" to select
multiplier "MULT" or "+" to select refueling
"FUEL."
[DOWN]
[SAVE] [ UP ]
FUEL USED CAL :
MULTIPLIER = 1.0
30167
Adjusts multiplier between 0.50 and 1.50.
Press "–" to select "DOWN," or "+" to select
"UP."
The multiplier is used to fine‑tune the fuel
gauge sender to correct for fuel used errors. If
the gauge indicates that 10 gallons of fuel
was used, but the actual fuel that was added
is 14 gallons, change the multiplier to 1.40. If
the gauge indicates that 10 gallons of fuel
was used, but the actual fuel that was added
is only 8 gallons, change the multiplier to
0.80.