Owner`s manual

SC 1000 TACHOMETER
26 eng
Tachometer Calibration ‑ External Sensors
DEPTH SENSOR
CALIBRATION
[DOWN] [SAVE] [ UP ]
OFFSET = 3 FEET
52676
Electronically configure a depth offset.
Entering a negative number gives you a
waterline offset. A positive number gives you
a keel offset. Press "–" or "+" to calibrate the
depth sensor offset "DOWN" or "UP."
DEPTH ALARM
CALIBRATION
[DOWN] [SAVE] [ UP ]
LEVEL = 2.5 FEET
52677
Enter a depth value. When the depth
transducer reads that value or below, the
shallow water alarm will sound. Press "–" or
"+" to calibrate the depth alarm level "DOWN"
or "UP."
23540
SPEED UNITS
MPH
[DOWN]
[SAVE]
[ UP ]
Changes the units in which speed is
displayed. Choose from: MPH (Miles Per
Hour), KN (Knots), or KMH (Kilometers Per
Hour).
[DOWN]
[SAVE]
[ UP ]
23539
DISPLAY UNITS
ENGLISH
Changes units of measure between English
or metric. Select "DOWN" or "UP" to change
between "ENGLISH" or "METRIC" units of
measure.
[ NO ]
[SAVE] [ YES ]
23547
SIMULATOR MODE
NO
Enables the simulation mode. (Used for
demonstration purposes only.)
[ NO ] [ YES ] [SCREENS]
43372
CALIBRATION
EXIT ?
Press "MODE/SELECT" to exit. Press "–" not
to exit and go through the calibrations again
or press "+" to go through the complete
"SCREENS" menu.
SIMULATOR MODE
NOTE: Simulator mode can only be use when the gauge is not
connected to a power package and is used for visual display
purposes.
Simulator Mode
[ NO ]
[ YES ]
[SAVE]
46443
SIMULATOR MODE
NO
Enables the simulation mode. (Used for
demonstration purposes only.)