Owner`s manual

SC 1000 TACHOMETER
eng 25
Tachometer Calibration ‑ External Sensors
TRIM FULL DOWN
CALIBRATION
THEN PRESS PLUS BUTTON
[DFLT] [SKIP] [SAVE]
52662
Trim the system to the full down position, then
press the "+" button to save the setting.
TRIM FULL UP
CALIBRATION
THEN PRESS PLUS BUTTON
[DFLT] [SKIP] [SAVE]
52663
Trim the system to the full up position, then
press the "+" button to save the setting.
TRIM TO TRAILER POINT
CALIBRATION
THEN PRESS PLUS BUTTON
[DFLT] [SKIP] [SAVE]
52664
Trim the system to the trailer point, then press
the "+" button to save the setting.
SPEED OPTION
CALIBRATION
[SKIP] [EDIT]
52665
This section configures the following speed
sensors. Select "EDIT" to calibrate the
sensors. Select "SKIP" to proceed to the
depth sensor screen.
PITOT SENSOR
100 PSI TYPE
CALIBRATION
[ NO ] [SAVE] [YES ]
52671
Select pitot transducer type. Choose between
100 or 200 psi. (100 psi is the most common.)
PITOT SENSOR
CALIBRATION
[DOWN] [SAVE] [ UP ]
MULTIPLIER = 1.00
52672
Adjust the pitot pressure sensor to correct
display readings that are too high/low. Press
"–" or "+" to calibrate the pitot sensor
multiplier "DOWN" or "UP."
PADDLE SENSOR
CALIBRATION
[DOWN] [SAVE] [ UP ]
PULSEFACTOR = 3.0
52673
Adjust paddle wheel frequency to correct
display readings that are too high/low. Press
"–" or "+" to calibrate the paddle sensor pulse
factor "DOWN" or "UP."
TRANSITION SPEED
CALIBRATION
[DOWN] [SAVE] [ UP ]
TRANSITION = 30 MPH
52674
Set the speed at which the gauge stops
reading the paddle wheel and starts using
pitot sensor or GPS to measure boat speed.
Press "–" or "+" to calibrate the transition
speed "DOWN" or "UP."