Owner`s manual

SC 1000 TACHOMETER
eng 23
Fuel Used Calibration
[DOWN]
[SAVE] [ UP ]
FUEL USED CAL :
MULTIPLIER = 1.0
30167
Adjusts multiplier between 0.50 and 1.50.
Press "–" to select "DOWN," or "+" to select
"UP."
The multiplier is used to fine‑tune the fuel
gauge sender to correct for fuel used errors. If
the gauge indicates that 10 gallons of fuel
was used, but the actual fuel that was added
is 14 gallons, change the multiplier to 1.40. If
the gauge indicates that 10 gallons of fuel
was used, but the actual fuel that was added
is only 8 gallons, change the multiplier to
0.80.
[DOWN]
[SAVE] [ UP ]
FUEL USED CAL :
AMOUNT
REFUELED = 0.0 G
30168
Adjusts fuel used calibration using the amount
of fuel replaced. Press "–" to select "DOWN,"
or "+" to select "UP."
The fuel option functions the same as the
multiplier. If the gauge indicates that 10
gallons of fuel was used, but the actual fuel
that was added is 14 gallons, change the
amount refueled to 14.0. If the gauge
indicates that 10 gallons of fuel was used, but
the actual fuel that was added is only 8
gallons, change the amount refueled to 8.0
gallons. The gauge will calculate the multiplier
and will automatically change the number in
the multiplier option.
CALIBRATION–EXTERNAL SENSORS
1. Press and hold the "MODE/SELECT" and "+" buttons for
approximately seven seconds until "SCREENS" appear.
2. Press "MODE/SELECT" to advance through the screen
selections to the exit screen and press the "+" button to
enter Fuel Tank Calibration.
3. Press "MODE/SELECT" to advance through the selections
to Calibration–External Sensors.
Tachometer Calibration ‑ External Sensors
EXTERNAL SENSORS ?
CALIBRATION
[SKIP]
[EDIT]
52653
Selects and calibrates external sensors that
are installed in the system. Select "SKIP" to
proceed to the speed options. Select "EDIT"
to proceed to external sensor selection.