Owner`s manual

SC 1000 TACHOMETER
eng 21
• Performing the tank calibration procedure without adding
fuel; the system will supply an estimated range value based
on linear interpolation of the sensor range values. This
mode does not factor in irregular tank shapes. You must edit
the tank calibration by entering a numerical value for the
capacity of the fuel tank. The linear readout is based on raw
sensor values.
• Performing the tank calibration procedure with adding fuel at
each calibration point; the system will display an estimated
range value that factors in the tank shape. You must edit the
tank calibration by adding fuel for 1/4, 1/2, 3/4, and full.
Failure to edit the tank calibration will automatically default
the fuel level to the liter/gallon capacity.
Tank Calibration
FUEL TANK 1 CAPACITY
CALIBRATION
CAPACITY = 26.2 G
[DOWN] [SAVE] [ UP ]
52647
Enter the capacity of the tank. Select
"DOWN" or "UP" to set the tank capacity.
Then press "SAVE." This option is the same
for tanks.
FUEL TANK 1
CALIBRATION
[SKIP] [EDIT]
52648
Select "EDIT" to enter the calibration mode of
the fuel tank. The calibration procedure is the
same for all tanks. Select "EDIT" to begin
tank level calibration.
DEFAULT CALIBRATION,
TANK CALIBRATION :
OR ADD FUEL ?
[DFLT]
[ADD ]
23994
Select "DFLT" to let SmartCraft calibrate the
tank levels. Select "ADD" to calibrate the tank
levels by adding fluid to the tank.
EMPTY TANK
CALIBRATING :
THEN PRESS PLUS BUTTON
[SKIP]
[SAVE]
23995
Empty the tank. Press the "+" button to save
the calibration level to empty.
FILL TANK TO 1/4
THEN PRESS PLUS BUTTON
[SAVE]
30427
Fill the tank to 1/4 full. Press the "+" button to
save the calibration level to 1/4 full.