User guide

OWC MERCURY ELITE PRO DUAL
SYSTEM SETUP
5
5. Install the upper hard drive, as shown below. Twist the black SATA connector
counterclockwise so that the red data cable crosses over the top of the smaller yellow, red,
and black power cables, as circled to the lower left. This ensures that the cables will not
come into contact with the fan during operation. Insert the black SATA connector into the
corresponding connector on the hard drive, then slide the hard drive toward the fan in
order to line up the screw holes in the hard drive with those on the inner chassis. Make
sure the SATA connector is seated firmly before continuing.
6. Using eight of the larger screws from the packet you removed from the inner chassis,
fasten the hard drives into the inner chassis. There are four screw holes on each side of the
inner chassis, as circled below in red.