Owner`s manual

Mercury Mambo Micro Powerchair Owner’s Handbook (Page 17) Part code: Z20943-00
6.4 Disassembling the Mambo Micro Powerchair
The Mambo Micro powerchair can be dismantled in to four pieces without any tools. The pieces are
the seat (weight 8.2kg), the front section (12kg), the rear section (16.1kg) and the battery pack
(9.6kg). Please follow the steps below:
1. Switch off the powerchair.
2. Flip up the footplate.
3. Unplug the joystick and remove the seat and battery pack
(as described in the ‘Operation’ section).
4. To fold the chassis, pull up on the red handle arrowed in the
photograph right (note: the seat post does not need
removing)
5. The two sections of the chassis can now be separated.
6.5 Assembling the Mambo Micro Powerchair
)
Suggestion:
The assembly procedure is very similar to the disassembly procedure in reverse. First
study the disassembly procedure above before consulting the assembly procedure below.
1. Place the rear section on its back end. Place the front
section so that the two pegs are resting in the
receivers on the rear section. Please see photograph
right.
2. Lift up the front section by the footplate until the
front and rear sections lock in position (shown by
arrow in photo). You will hear a click when the
sections lock in position.
3. Lower the chassis and insert the battery pack.
4. Replace the seat, ensuring it locks in position.
5. Plug in the joystick cable.