User`s guide

To install a module, push the retaining latches at either end of the

socket outwards. Position the memory module correctly and insert

it into the DIMM socket. Press the module down into the socket so

that the retaining latches rotate up and secure the module in place

by fitting into notches on the edge of the module.

Setting Jumper Switches

Jumpers are sets of pins connected together with jumper caps. The

jumper caps change the way of mainboard’s operation by changing

the electronic circuits on the mainboard. If a jumper cap connects

two pins, we say the pins are SHORT. If a jumper cap is removed

from two pins, the pins are OPEN.

JP2

JP1

Jumper JP1: Clear CMOS Memory

Use this jumper to clear the contents of the CMOS memory. You

may need to clear the CMOS memory if the settings in the Setup

Utility are incorrect and prevent your mainboard from operating.

To clear the CMOS memory, disconnect all the power cables from

the mainboard and then move the jumper cap into the CLEAR

setting for a few seconds.

Function Jumper Setting

Normal Operation Short Pins 1-2

Clear CMOS Memory Short Pins 2-3