Specifications

CA79

REPAIR

Some damaged propellers can be repaired. See your dealer.

CD583

INSTALLATION (BRAVO TWO)

IMPORTANT: If reusing tab washer,carefully inspect tabs for cracks or other damage. Replace tab

washer if condition is questionable.

1 Apply a liberal coat of one of the following Quicksilver lubricants to propeller shaft: Anti-Corrosion Grease,

Special Lubricant 101, or 2-4-C Marine Lubricant.

2 Slide thrust hub into propeller hub, with stepped side toward propeller hub.

3 Align splines and place propeller and thrust hub on propeller shaft.

4 Place continuity washer and tab washer onto shaft.

5 Install propeller nut. Tighten nut securely. A minimum of 55 lbs. ft. (75 N.m) torque is required. Bend three

tabs on tab washer down into grooves in spline washer. After first use, bend the three tabs straight, retighten

propeller nut to minimum 55 lbs. ft. torque (75 N.m). Bend tabs back down into splint washer Check propeller

at least after 20 hours of operation. Do not operate with loose propeller.

CB222

INSTALLATION (BRAVO THREE)

6 Apply a liberal coat of one of the following Quicksilver lubricants to both propeller shafts: Special Lubricant

101, 2-4-C Marine Lubricant, or Anti-Corrosion Grease.

7 Slide forward thrust hub onto propeller shaft, with tappered side toward propeller hub (Toward end of shaft).

8 Align splines and place propeller on propeller shaft.

9 Install propeller nut. Tighten nut securely. A minimum of 100 lbs. ft. (136 N·m) torque is required. Check pro-

peller at least after 20 hours of operation. Do not operate with loose propeller.

10Slide aft thrust hub onto propeller shaft, with tappered side toward propeller hub (Toward end of shaft).

11 Align splines and place propeller on propeller shaft.

12Install propeller nut. Tighten nut securely. A minimum of 60 lbs. ft. (81 N·m) torque is required. Check propeller

at least after 20 hours of operation. Do not operate with loose propeller.