Specifications

77
CD205
EXTERNAL COMPONENTS
Whenever two or more dissimilar metals (like those found on the sterndrive) are submerged in a conductive solu-
tion, such as saltwater, polluted water, or water with a high mineral content, a chemical reaction takes place caus-
ing electrical current to flow between metals. The electrical current flow causes the metal that is most chemically
active, or anodic, to erode. This is known as galvanic corrosion and, if not controlled, it will in time cause the need
for replacement of power package components exposed to water.
IMPORTANT: Replace sacrificial anodes if eroded 50% or more.
1 Universal Anodic Plate - serves as a sacrificial anode.
Remove plug from drive shaft housing to access attaching screw and insert 1/2 inch socket. Unthread attaching
screw and remove universal anodic plate. Do not remove screw. Install new anodic plate and tighten screw
securely. Install plug.
2 Anodic Plate - serves as a sacrificial anode. Unscrew both attaching screws and remove. Install a new anodic
plate and tighten securely.
3 MerCathode System - should be tested to ensure adequate output.
Test should be made where boat is moored, using Quicksilver Reference Electrode and Test Meter. Contact your
Authorized MerCruiser Dealer to arrange for this test.
4 Anode Kit (if so equipped) - Mounted to boat transom. Acts as a sacrificial anode. Replace as required.
CA163
5 Trim Cylinder Anodes - are mounted on each trim cylinder. To replace the trim cylinder anodes:
A Remove two screws from each anode.
B Install new anodes and tighten securely.
CD359
6 Propeller Anode (Bravo One) - is located in front of the propeller, between the front side of the propeller and
the gear housing. Refer to “Propeller” section in this manual for propeller removal and installation. To replace
the propeller anode:
A Remove propeller.
B Remove two screws from anode.
C Install new anode and tighten securely.
D Reinstall propeller.