Specifications

70
CD573
71362
1
1
70355
70062
1
1A
1B
1C
1D
1E
CD603
Cleaning Quicksilver Seawater Strainer
NOTE: Refer to manufacturers instructions if equipped with other than a Quicksilver seawater strainer.
CAUTION
When cleaning seawater strainer, close seacock, if so equipped. If boat is not equipped with a seacock,
remove and plug seawater inlet hose to prevent a siphoning action that may occur, allowing seawater
to flow from the drain holes or removed hoses.
1 With engine off, close seacock if so equipped, or remove and plug seawater inlet hose. Remove screws and
washers, and cover. Remove strainer, drain plug and washer, and clean any debris from strainer housing; flush
both strainer and housing with clean water. Check gasket - replace when necessary (if it leaks). Reinstall drain
plug and washer. Reattach cover with screws and washers. Prior to starting engine, open seacock if so equipped,
or remove plug from seawater inlet hose and reconnect. Tighten hose clamps securely. After starting engine,
check for leaks, and/or air in system (which would indicate an external leak).
A Screws and Washers
B Cover
C Strainer
D Drain Plug and Washer
E Gasket