Specifications

48
CE35
OPERATION CHART
STARTING
PROCEDURE
AFTER
STARTING
WHILE
UNDERWAY
STOPPING &
SHUT DOWN
Turn on and run engine
compartment bilge
blower, if so equipped,
for five minutes.
Observe all gauges
and warning lights to
check condition of en-
gine. If not normal,
stop engine.
Frequently observe
all gauges and indi-
cator lights to moni-
tor engine condition.
Shift remote control
lever to neutral posi-
tion.
Check for leaks - fuel,
oil, water, fluid, etc.
Check for fuel, oil, wa-
ter, fluid, and exhaust
leaks, etc.
Run engine at idle
speed several minutes
to allow it to cool down.
Check shift and
throttle control opera-
tion.
Prime fuel injection
system, if necessary.
Turn key switch to OFF
position.
Turn battery switch
OFF, if so equipped.
Turn key switch to
“RUN” and check that
lights and indicator
lamps come on.
Close seacock, if so
equipped.
Turn key switch to
START, AFTER pre-
heater indicator lamp
has gone out. Release
key when engine starts.
Flush seawater cool-
ing circuit, if operating
in saltwater area.
Check that charge indi-
cator and oil pressure
indicator lamps go out
AFTER engine starts.
Warm-up engine at idle
rpm for several min-
utes.
Open seacock, if so
equipped.
Open fuel shutoff
valve, if so equipped.
Open engine hatch.
Air out bilge complete-
ly.
Turn battery switch
ON, if so equipped.
Check steering opera-
tion.
Close fuel shutoff
valve, if so equipped.
CB13
IMPORTANT: Starting procedure if engine is shut-off or stops with drive unit in gear.
1. Pull/push remote control handle to neutral-lock position (it will be necessary to exert force to move
handle).
2. Turn key to start position, momentarily, to release clutch from gear.
3. Resume normal starting procedure.