Service manual

REMOVAL, INSTALLATION AND ADJUSTMENTS
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 2A-13
IMPORTANT: Hose must not come in contact with steering system components or the
engine coupler and drive shaft.
2. Connect gear lube monitor hose.
3. Install water inlet fitting with gasket. Torque bolts and star washers to 45 lb-in. (5 Nm).
76640
a
b
c
d
a-Hose To Gear Lube Monitor
b-Hose Clamp
c-Water Inlet Fitting
d-Bolts And Star Washers
4. On Some Models: The gear lube hose may be routed toward the port side of the engine.
Secure the hose at the top side of the water fitting using the hose clip as shown. Torque
bolts and star washers to 45 lb-in. (5 Nm).
76635
a
b
c
d
a-Gear Lube Monitor Hose
b-Hose Clip
c-Water Hose Fitting
d-Bolts And Star Washers
INDEX