Service manual

REMOVAL, INSTALLATION AND ADJUSTMENTS SERVICE MANUAL NUMBER 28
Page 2A-2 90-863160 MAY 2000
Torque Specifications
NOTE: Securely tighten all fasteners not listed below.
Fastener Location
lb-in. lb-ft Nm
Exhaust Pipe to Gimbal Housing Screws 23 31
Block Off Plate to Gimbal Housing Screws 23 31
Propeller Nut
1
55 75
Drive Unit Shift Cable Locknut
Tighten Nut Until It
Contacts Flat Washer, Then Loosen 1
Turn
Steering Cable Coupler Nut 35 48
Steering System Pivot Bolts 25 34
Transom Assembly Attaching Screws and
Nuts
23 31
Power Steering Hydraulic Hose Fittings 23 31
Sterndrive Unit to Bell Housing Attaching
Nuts
50 68
1
: Amount specified is MINIMUM.
Lubricants / Sealants / Adhesives
Description Part Number
Quicksilver 2-4-C Marine Lubricant with
Teflon
92-825407A12
Quicksilver Special Lubricant 101 92-13872A1
Perfect Seal 92-34227-1
Liquid Neoprene 92-25711--3
Quicksilver Anti-Corrosion Grease 92-78376A6
Quicksilver Engine Coupler Spline Grease 92-816391A4
Special Lubricant 101 92–13872A1
Tools
Description Part Number
Shift Cable Adjustment Tool 91-12427
Engine Alignment Tool Assembly 91-805475A1
INDEX