Service manual

SERVICE PROCEDURES REQUIRING MAJOR DISASSEMBLY SERVICE MANUAL NUMBER 28
Page 4B-52 90-863160 MAY 2000
3. Install shift cable wrapping approximately 2 in. from gimbal housing.
76639
a
a-Shift Cable Wrapping
CAUTION
Water leakage may result if clamp is not installed properly. Check that bellows end
is not flattened out when crimping in the followIng step.
4. Install and compress shift cable bellows crimp clamp, maintaining a 1/2 in. diameter
round outer diameter Ensure that clamp is crimped evenly to maintain a good seal
between bellows and shift cable. Do NOT allow bellows to flatten.(Plans for Crimp
Clamp Tool are on p. 4B-57)
22117
a
a-Crimp Clamp
INDEX