Service manual

SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 4A-31
Installation
NOTE: Bellows adhesive is not used when installing an exhaust tube.
CAUTION
Exhaust tube clamp may corrode if grounding clip is not installed.
1. Position grounding clip on exhaust tube as shown.
22184
b
a
a-Exhaust Tube
b-Grounding Clip
2. Install exhaust tube on gimbal housing as follows:
a. Position tube so that SIDE markings on tube are facing toward the right and left
sides.
b. Position clamp so that screw will align with screwdriver access hole in port (left) side
of gimbal housing.
c. Tighten clamp. Torque to 35 lb-in. (4 Nm).
22184
c
b
a
a-Exhaust Tube
b-Clamp
c-Side Marking
INDEX