Service manual

SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 4A-27
13. Remove tools and install cable on shift plate assembly, being careful not to lose
adjustment.
22120
a
b
a-Barrel
b-Hole In Tool
Exhaust Bellows (If Equipped)
Removal
1. Remove sterndrive unit. Refer to Section 2A.
2. Loosen clamps and remove bellows.
22116
a
a
b
a-Clamps
b-Bellows
Cleaning and Inspection
1. Inspect exhaust bellows for internal charring, cracks, cuts or hardening.
2. Clean old adhesive from bellows mounting flange on gimbal housing and on bell housing
with lacquer thinner.
3. Clean old adhesive from mounting surface of exhaust bellows if using old bellows.
4. Roughen exhaust bellows mating surfaces with sandpaper and wipe clean with lacquer
thinner.
INDEX