Service manual

BRAVO THREE GEAR HOUSING SERVICE MANUAL NUMBER 28
Page 3D-34 90-863160 MAY 2000
13. Reinstall clamping plate on gear housing with nuts and 4 washers. Tighten securely.
72266
a
a-Clamp Plate (P/N 91-43559T)
14. Using a dial-type lb-in. torque wrench, check the rolling preload by turning driveshaft
with a slow steady motion (3-5 lb-in. [0.3-.6 Nm]). If necessary, add or subtract shims
from beneath spacer to bring the preload into the specified range.
72269
b
a
a-Dial-Type lb-in. Torque Wrench
b-Drive Shaft Adaptor (P/N 91-61077T)
15. Ensure clamp plate has been reinstalled after adjusting preload in the previous step. It
must be in place for checking pinion height in the following procedure.
INDEX