Service manual

BRAVO THREE GEAR HOUSING SERVICE MANUAL NUMBER 28
Page 3D-30 90-863160 MAY 2000
4. Apply a light coat of Loctite 242 to inside diameter of thrust cap. Ensure that Loctite does
not contact shim mating surfaces. Install thrust cap and appropriate size shim on outer
propeller shaft. Ensure that cap is straight while pressing into place.
71799
72212
c
a
b
a-Thrust Cap
b-Shim
c-Outer Propeller Shaft
5. Ensure that all needle bearings are installed in driveshaft needle bearing case. Use
needle bearing assembly lubricant to hold bearings in place.
72261
6. Install front driven gear assembly and original thickness shims into gear housing.
72249
a
a-Front Driven Gear Assembly And Shims
INDEX