Service manual

BRAVO THREE GEAR HOUSING
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 3D-27
2. Coat outer diameter of oil seal with Loctite 271 and press oil seal into bearing carrier
using seal installation tool until tool bottoms out against housing. Lubricate lips of oil seal
and fill area between lips of seal with Quicksilver Special Lubricant 101.
75897
a
b
a-Seal Installation Tool (P/N 91-805372)
b-Bearing Carrier
Speedometer Water Passage
Inspection and Cleaning
1. Inspect opening (pitot tube), on leading edge of gear housing, for obstruction. Clean
opening with a short piece of wire, if necessary. If obstruction cannot be removed with
wire, carefully reopen tube using a 5/64 in. (2 mm) diameter drill bit. Do not drill beyond
a depth of 2-7/16 in. (62 mm).
72448
a
a-Opening (Pitot Tube)
2. Inspect water passage seal for nicks, cuts or distortion. Replace if necessary.
72449
a
a-Water Passage Seal
INDEX