Service manual

BRAVO THREE GEAR HOUSING

SERVICE MANUAL NUMBER 28

90-863160 MAY 2000 Page 3D-25

Bearing Cup Removal

1. Remove bearing cup and shims using slide hammer puller. Measure shims for reas-

sembly reference.

NOTE: When pulling bearing cup with puller, shims will be damaged. DO NOT reuse shims.

19808

a-Slide Hammer Puller (P/N 91-34569A1)

b-Bearing Cup

c-Shims

Bearing Cup Installation

1. Install front driven gear bearing cup and original thickness shims using bearing cup driv-

er and driver rod. If shims were lost or damaged where original thickness cannot be de-

termined, install a .015 in. (0.38 mm) shim for a starting point. Ensure cup is not canted.

Coat cup outer diameter with Quicksilver High Performance Gear Lube.

75958

a-Shim(s)

b-Bearing Cup

c-Driver (P/N 91-805454)

d-Old Propeller Shaft or Driver Rod

INDEX