Service manual

BRAVO TWO GEAR HOUSING SERVICE MANUAL NUMBER 28
Page 3C-40 90-863160 MAY 2000
28. Tighten the retainer to the proper preload using the following procedure.
a. Tighten retainer in small increments using retainer nut wrench.
22112
a
a-Bearing Carrier Retainer Wrench (P/N 91-17257)
b. Using an lb-in. torque wrench , check overall gear housing bearing preload by rotat-
ing propeller shaft in direction of normal rotation with a slow steady motion.
a
b
a-Torque Wrench (P/N 91-66274)
b-Propeller Nut (under socket)
c. Continue tightening bearing carrier retainer nut and checking preload until specified
bearing preload is attained.
INDEX