Service manual

BRAVO TWO GEAR HOUSING SERVICE MANUAL NUMBER 28
Page 3C-26 90-863160 MAY 2000
Driven Gear Bearing Installation
1. Apply Gear Lube to inside diameter of new bearing. Place a suitable mandrel (old
bearing race) against new bearing race. Place another mandrel on face of gear and
press gear and bearing together.
22108
a
b
c
d
a-Hard Wood Or Metal Block
b-Driven Gear
c-Tapered Roller Bearing
d-Mandrel – Contacting Inner Race
Driven Gear Bearing Cup Removal and Inspection
1. Remove bearing cup and shims using slide hammer puller. Replace tapered roller
bearing and cup if cup is pitted, grooved, scored, worn uneven, discolored from
overheating or has metal particles embedded in the cup.
19808
a
b
c
a-Slide Hammer Puller, 91-34569A1
b-Bearing Cup
c-Shims
INDEX