Service manual

BRAVO ONE GEAR HOUSING
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 3B-41
IMPORTANT: Bearing carrier and threads on retainer must be lubricated to prevent
corrosion and cracking in gear housing. Use Quicksilver Special Lubricant 101 on
retainer threads; coat outside diameter on carrier mating surfaces with perfect seal.
25. Lubricate bearing carrier seals and fill space between seals with Quicksilver 2-4-C
Marine Lubricant with Teflon. Coat carrier mating surfaces with Perfect Seal.
22111
a
b
b
a-Space Between Seals
b-Mating Surfaces
26. Install bearing carrier and tab washer in gear housing. Align inner tab of tab washer with
V-notch in bearing retainer and outer tab with hole in gear housing.
27. Lubricate threads on bearing carrier retaining nut with Quicksilver Special Lubricant
101. Install and tighten bearing carrier retainer nut until resistance to propeller shaft
rotation can be felt (to preload bearings).
d
e
c
c-Tab Washer – V-Notch In Recess In Carrier
d-Bearing Carrier
e-Bearing Carrier Retainer Nut
INDEX