Service manual

DRIVE SHAFT HOUSING
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 3A-59
TORQUE CONVERSION CHART FOR U-JOINT RETAINER NUT TOOL
Torque Wrench Length in Inches (mm)
a
Torque Wrench Reading in lb-ft (Nm) to
Achieve 200 lb-ft (271 Nm)
15 (381)
16 (406)
17 (432)
18 (457)
19 (483)
20 (508)
21 (533)
22 (559)
23 (584)
24 (610)
25 (635)
26 (660)
27 (686)
28 (711)
29 (737)
30 (762)
31 (787)
32 (813)
33 (838)
34 (864)
35 (889)
36 (914)
111 (151)
114 (155)
117 (159)
120 (163)
123 (167)
125 (170)
127 (172)
129 (175)
131 (178)
133 (180)
135 (183)
136 (184)
138 (187)
140 (190)
141 (191)
143 (194)
144 (195)
145 (197)
147 (200)
148 (201)
149 (202)
150 (203)
26363
a
12"
Typical Bravo Retainer Nut Tool Shown
a-Torque Wrench Length
TORQUING BRAVO U-JOINT BEARING RETAINER NUT
Use the following procedure to allow torquing retainer nut with a torque wrench.
a. On beam-type torque wrenches, measure from square drive to fulcrum (pivot) point
of handle.
b. On click-stop or dial type torque wrenches, measure from square drive to reference
mark on handle (2 bands, etc.).
6. Check that timing marks are still properly aligned (by turning U-joint, if necessary). If
marks have moved; remove U-joint assembly and start over beginning with step (3).
• Refer to “Special Information” on page 23 if shift cam assembly is being replaced.
INDEX