Service manual

DRIVE SHAFT HOUSING

SERVICE MANUAL NUMBER 28

90-863160 MAY 2000 Page 3A-47

Drive Shaft Housing and Top Cover - Bearings and Bearing

Sleeves

Inspection

1. Inspect needle bearing races in top cover and in drive shaft housing for pitting, grooves,

discoloration or embedded particles. If any of these conditions exist, replace race.

2. Condition of the bearing surfaces on the clutch shaft are an indication of the condition

of the bearings in the top cover and drive shaft housing. Inspect bearing surface for pit-

ting, grooves, discoloration or embedded particles. If any of these conditions exist, then

replace bearings and shaft.

Bearing Sleeve Removal (Top Cover)

1. Place puller jaws around sleeve.

22083

a-Top Cover

b-Puller Jaws (2 Halves) – (91-90244A1)

c-Bearing

2. Position puller guide over jaws and install bolt.

22084

a-Puller Guide (91-90244A1)

b-Puller Bolt (90-90244A1)

c-Top Cover

d-Washers

INDEX