Manualshelf

Service manual

ManualsBrandsMercury ManualsBoatBravo Three
131132133134135136137138139140
DRIVE SHAFT HOUSING
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 3A-37
2. Install three new O-rings on coupling end of U-joint shaft.
73922
a
b
a-O-ring Grooves
b-O-rings
3. Coat outside diameter of oil seal with Loctite 271 and press oil seal in with lip of seal
facing pinion gear, using bearing driver until tool bottoms out against carrier.
NOTE: The U-joint seal is located in the seal carrier on standard Bravo drives and in the
bearing retainer nut on Bravo X, XZ, XR, and Diesel Bravo.
22103
22103
a
b
c
b
c
Standard Bravo Shown
a-Oil Seal
b-Oil Seal Carrier
c-Bearing Driver (91-813653T)
4. Lubricate lip of oil seal (a) with 2-4-C Marine Lubricant with Teflon.
22435
a
a-Oil Seal Lip
INDEX