Specifications

New Shimming procedure
(continued)
• Step 25) In this step you will make the required shim race changes
and redo the process, by first removing the dial indicator
from the holding block, loosen the lash flag and remove
it from the stub shaft, next remove the dial indicator rod
to make room for the spanner wrench so you can
remove the pinion gear and bearing pack from the
housing. Taking care not to damage the pinion gear
shims in the snout.
• Step 26) Remove the top cover.
• Step 27) Next remove the driven gear pack and make the proper
changes for the shim race under the bottom gear first,
then reinstall the driven gear pack aligning the (+) plus
over (-) minus on the brass sleeve to the hash marks on
the housing and make the proper shim race change for
the top gear, then reinstall the top cover and torque to
specifications.
• Step 28) To recheck your work repeat the process following steps
8 through 22.