Specifications

New Shimming procedure
(continued)
• Step 22) Now tighten the clamp block on the stub shaft locking it to
the shaft
.
• Step 23) While holding the driven gear in a locked position with the
clamp tool, you will now check the amount of gear lash you
have on this gear to the pinion gear, it must be from .000 to
.000 if the lash is more than the high limit per the lash chart
you will have to change the shim race to a thicker race,
making sure you record the gear lash reading, Do not
make any changes at this time.
The shim races will change by (.0254) .001 in. in thickness.
(example for a (1.60mm) .063 the next thicker shim race
will be a (1.62mm) .064 and etc.) from (1.47mm) .058
though (1.68mm) .066. The change should be a one to
one match.
• Step 24) You now have to remove the clamp tool from the bottom
gear and change it to the top gear and repeat steps 21 and
22 performed previously.