Maintenance and Service Guide

52,500 miles
Change engine oil and replace oil filter
Inspect cabin air filter (if equipped)
Rotate tires, inspect tires for wear and measure
tread depth
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
60,000 miles
Change engine oil and replace oil filter
Change automatic transmission fluid and filter on
all vehicles equipped with the TorqShift
transmission. Consult your dealer for your particular
requirements.
Replace cabin air filter (if equipped)
Replace climate-controlled seat filter (if equipped)
Replace engine air filter
Replace fuel filter (except Escape, Mariner,
F-Series [non Super Duty],
Expedition/Navigator [short wheel base only],
E-Series)
Replace wheel bearing grease and grease seals
on 4x2 front wheel bearings (if non-sealed
bearings)
Inspect steering linkage, ball joints, suspension,
tie rod ends, driveshaft, and U-joints (lubricate if
equipped with Zerk fittings)
Torque the rear U-bolts (Transit Connect only)
Inspect engine cooling system and hoses
Inspect brake pads, shoes, rotors, drums, brake
lines and hoses and parking brake system.
Inspect half shaft boots (if equipped)
Inspect exhaust system and heat shields
Inspect and lubricate 4x4 front axle U-joints
Rotate tires, inspect tires for wear and measure
tread depth
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
N
ORMAL
S
CHEDULE
T
RUCKS
,F
ULLSIZE
V
ANS
& SUV
S
Scheduled Maintenance
19
2010 Scheduled Maintenance Guide (smg)
Scheduled Maintenance Guide, 1st Printing
USA (fus)
Normal Schedule
Trucks, Fullsize
Vans & SUVs