Maintenance and Service Guide

120,000 miles
Change engine oil and replace oil filter
Replace cabin air filter (if equipped)
Replace climate-controlled seat filters (if
equipped)
Replace engine air filter
Replace fuel filter (except Escape, Mariner,
F-Series [non Super Duty],
Expedition/Navigator [short wheel base only],
E-Series)
Replace PCV valve on all light trucks over
6,000 lbs. Gross Vehicle Weight (GVW)
(except 3V engines)
Change automatic transmission fluid on all
vehicles equipped with the TorqShift
transmission. Consult your dealer for your
particular requirements.
Replace wheel bearing grease and grease seals
on 4x2 front wheel bearings (if non-sealed
bearings)
Inspect steering linkage, ball joints, suspension,
tie rod ends, driveshaft, and U-joints (lubricate if
equipped with Zerk fittings)
Inspect engine cooling system and hoses
Inspect brake pads, shoes, rotors, drums, brake
lines and hoses and parking brake system.
Inspect half shaft boots (if equipped)
Inspect exhaust system and heat shields
Inspect accessory drive belts
Inspect automatic transmission fluid level (if
equipped with an underhood dipstick)
Inspect and lubricate 4x4 front axle U-joints
Rotate tires, inspect tires for wear and measure
tread depth (vehicles with dual rear wheels
should only rotate if unusual wear is noted)
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
N
ORMAL
S
CHEDULE
T
RUCKS
,F
ULLSIZE
V
ANS
& SUV
S
Scheduled Maintenance
25
2009 Scheduled Maintenance Guide (smg)
Scheduled Maintenance Guide
USA (fus)
Normal Schedule
Trucks, Fullsize
Vans & SUVs