Maintenance and Service Guide

105,000 miles
Change engine oil and replace oil filter
Change manual transmission fluid (except Escape)
Replace cabin air filter (if equipped)
Replace PCV valve on all light trucks under
6,000 lbs. Gross Vehicle Weight (GVW)
(except 3V engines)
Change rear axle fluid only on vehicles equipped
with DANA axles (see Special Operating
Conditions on page 42 and Exceptions on page
47)
Change Motorcraft Premium Gold Engine Coolant
(see Exceptions on page 47 and Premium Gold
Coolant Change Record on page 48)
Inspect steering linkage, ball joints, suspension,
tie rod ends, driveshaft, and U-joints (lubricate if
equipped with Zerk fittings)
Inspect engine cooling system and hoses
Inspect brake pads, shoes, rotors, drums, brake
lines and hoses and parking brake system.
Inspect half shaft boots (if equipped)
Inspect exhaust system and heat shields
Inspect automatic transmission fluid level (if
equipped with an underhood dipstick)
Inspect and lubricate 4x4 front axle U-joints
Rotate tires, inspect tires for wear and measure
tread depth (vehicles with dual rear wheels
should only rotate if unusual wear is noted)
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
112,500 miles
Change engine oil and replace oil filter
Rotate tires, inspect tires for wear and measure
tread depth (vehicles with dual rear wheels
should only rotate if unusual wear is noted)
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
N
ORMAL
S
CHEDULE
T
RUCKS
,F
ULLSIZE
V
ANS
& SUV
S
24
Scheduled Maintenance
2009 Scheduled Maintenance Guide (smg)
Scheduled Maintenance Guide
USA (fus)