Maintenance and Service Guide

120,000 miles
Change engine oil and replace oil filter
Replace cabin air filter (if equipped)
Replace climate-controlled seat filter (if equipped)
Replace engine air filter
Replace fuel filter
Replace PCV valve on all light trucks over 6,000
lbs. Gross Vehicle Weight (GVW) (except 3V
engines)
Change automatic transmission fluid on all
vehicles equipped with the TorqShift
transmission. Replace the externally-mounted
remote filter element for all TorqShift transmissions
(if equipped). Replace the internal TorqShift
transmission fluid filter located inside
the transmission bottom pan (vehicles without
externally-mounted remote filter only). Inspect
automatic transmission/transaxle fluid level
on all other vehicles if equipped with dipstick.
Consult your dealer for particular requirements.
Replace wheel bearing grease and grease seals
on 4x2 wheel bearings (if non-sealed bearings)
Inspect steering linkage, suspension and, if
equipped, driveshaft, ball joints and U-joints
Inspect engine cooling system and hoses
Inspect brake pads, shoes, rotors, drums, brake
lines and hoses and parking brake system.
Inspect half shaft boots (if equipped)
Inspect exhaust system and heat shields
Inspect drive belts
Inspect automatic transmission fluid level (if
equipped with an underhood dipstick)
Lubricate ball joints and U-joints (if equipped
with zerk fittings)
Inspect and lubricate 4x4 front axle U-joints
Perform multi-point inspection (recommended)
Rotate tires, inspect tires for wear and measure
tread depth (vehicles with dual rear wheels
should only rotate if unusual wear is noted)
Inspect wheels for end play and noise
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
N
ORMAL
S
CHEDULE
T
RUCKS
,F
ULLSIZE
V
ANS
& SUV
S
Scheduled Maintenance
25
2008 (smg)
Scheduled Maintenance Guide
USA (fus)
Normal Schedule
Trucks, Fullsize
Vans & SUVs