Maintenance and Service Guide

105,000 miles
Change engine oil and replace oil filter
Change manual transmission fluid (except Escape)
Replace cabin air filter (if equipped)
Replace PCV valve on all light trucks under
6,000 lbs. Gross Vehicle Weight (GVW)
(except 3V engines)
Change rear axle fluid only on vehicles equipped
with DANA axles which use synthetic lubricant
(see Special Operating Conditions on page 42 and
Exceptions on page 47)
Change Motorcraft Premium Gold Engine Coolant
(see Exceptions on page 47 and Premium Gold
Coolant Change Record on page 48)
Inspect steering linkage, suspension and, if
equipped, driveshaft, ball joints and U-joints
Inspect engine cooling system and hoses
Inspect brake pads, shoes, rotors, drums, brake
lines and hoses and parking brake system.
Inspect half shaft boots (if equipped)
Inspect exhaust system and heat shields
Inspect engine air filter
Inspect automatic transmission fluid level (if
equipped with an underhood dipstick)
Lubricate ball joints and U-joints (if equipped
with zerk fittings)
Inspect and lubricate 4x4 front axle U-joints
Perform multi-point inspection (recommended)
Rotate tires, inspect tires for wear and measure
tread depth (vehicles with dual rear wheels
should only rotate if unusual wear is noted)
Inspect wheels for end play and noise
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
112,500 miles
Change engine oil and replace oil filter
Perform multi-point inspection (recommended)
Rotate tires, inspect tires for wear and measure
tread depth (vehicles with dual rear wheels
should only rotate if unusual wear is noted)
Inspect wheels for end play and noise
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
N
ORMAL
S
CHEDULE
T
RUCKS
,F
ULLSIZE
V
ANS
& SUV
S
24
Scheduled Maintenance
2008 (smg)
Scheduled Maintenance Guide
USA (fus)