Maintenance and Service Guide

120,000 miles
❑
Change engine oil and replace oil filter.
❑
Inspect tires for wear and rotate.
❑
Inspect brake pads/shoes/rotors/drums, brake
lines & hoses, and parking brake system.
❑
Inspect wheel ends for endplay and noise.
❑
Inspect engine cooling system and hoses.
❑
Inspect exhaust system and heat shields.
❑
Inspect steering linkage, ball joints, suspension
and, if equipped, half shafts, driveshaft and
u-joints.
❑
Replace engine air filter.
❑
Replace fuel filter (except natural gas) (see page
46).
❑
Replace cabin air filter, if equipped.
❑
Replace PCV on all light trucks over 6,000 Gross
Vehicle Weight (except 5.4L 3V engine, see your
dealer).
❑
Change automatic transmission fluid on all
vehicles equipped with 4R100. Inspect
automatic transmission/transaxle fluid level on
all other vehicles, if equipped with
dipstick. Consult your dealer for your particular
requirements.
❑
Replace climate-controlled seat filters (Navigator,
Expedition, and Aviator) if equipped.
❑
Change manual transmission fluid.
❑
Lubricate 4X2 wheel bearings, replace grease
seals, and adjust bearings (if not equipped
with sealed bearings).
❑
Lubricate 4X2 ball joints and steering linkage if
equipped with zerk fittings.
❑
Lubricate 4X4 front hub needle bearings (F
Super Duty).
❑
Replace camshaft belt on 4 cylinder engine
(2.0L Escape).
❑
Inspect and lubricate 4X4 front axle shaft u-joints
(F250/350/450/550 and Excursion).
❑
Inspect fuel tanks (natural gas and propane
only).
❑
Multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
N ORMAL S CHEDULE T RUCKS ,F ULLSIZE V ANS & SUV S
26 Scheduled Maintenance
Normal Schedule Trucks, Fullsize Vans & SUVs