Specifications

TROUBLESHOOTING
eng 139
Starter Motor Will Not Crank the Engine
POSSIBLE CAUSES
• Lanyard stop switch not in "RUN" position.
• Blown 5 amp fuse. Check DTS power harness circuit fuse.
Refer to Maintenance section.
• Outboard is not shifted to neutral position.
• Shift actuator failure. "Gear Shift Diff" error message shown
on System View. Refer to Maintenance section.
• Weak battery or battery connections are loose or corroded.
• Ignition key switch failure.
• Wiring or electrical connection faulty.
• Starter motor solenoid or slave solenoid failure.
Engine Will Not Start
POSSIBLE CAUSES
• Lanyard stop switch not in "RUN" position.
• Battery not fully charged.
•
Incorrect starting procedure. Refer to Operation section.
• Old or contaminated fuel.
• Fuel is not reaching the engine.
• Fuel tank is empty.
• Fuel tank vent not open or restricted.
• Fuel line is disconnected or kinked.
• Primer bulb not squeezed.
• Primer bulb check valve is faulty.
•
Fuel filter is obstructed. Refer to Maintenance section.
• Fuel pump failure.
• Fuel tank filter obstructed.
•
Open 20 amp fuse. Check fuses, refer to Maintenance
section.
• Threaded connection of an air hose is loose.
• Ignition system component failure.