Installation manual

200/225/250/275 VERADO 4-STROKE

90-10238051 Page 11 / 51

• To reduce noise on aluminum or metal hulls, isolate steering hoses from hull with

suitable non-abrasive hangers.

• Steering hoses from steering wheel helm must be free of twists or stress. Gently

secure hose bundle together with a cable tie, located approximately 25.4 cm

(10 in.) from the steering wheel helm.

• Do not mount pump on an angle greater then 15° from vertical position.

• The pump electrical wiring must be within reach of the auxiliary battery.

• Pump should be mounted in an area that allows sound enclosure, cover removal,

and easy access to the fill cap.

• Install pump in an area where bilge water will not contaminate the pump.

• To reduce transmitted noise, mount pump on wood or fiberglass surface. Avoid

mounting pump on aluminum or steel surfaces.

REQUIRED MOUNTING CLEARANCES FOR THE POWER STEERING PUMP

ob01458

a - 215 mm (8 1/2 in.)

b - 310 mm (12 7/32 in.) to top cover (not shown)

c - 285 mm (11 1/4 in.)

d - 432 mm (17 in.) clearance required for cover removal

INSTALLING POWER STEERING PUMP

1. The power steering pump can be mounted two ways:

• On a side of the internal bulkhead

• Mounted on the floor