Installation manual

90-898305

1-8

IMPORTANT: Avoid sharp bends in the data harness. Minimum bend radius

should be 7.6 cm (3 in.) for the final wiring installation.

1. Inspect the routing path to make sure surfaces are free of any sharp edges

or burrs that could cut the harness.

2. Install cable pulling tool to data harness.

3. Secure pulling tool with 2 cable ties.

IMPORTANT: The cables ties must be tight to prevent any slipping during

installation.

IMPORTANT: Carefully inspect data harness pins to ensure all pins are

securely fastened to data harness connector end following installation.

NOTE: Data harness should be secured with mounting clips or cable ties

along the routing path.

Dielectric Grease

• Dielectric grease will no longer be used on electrical connection except

the 8 pin cannon plug on 2005 product Improved electrical connection

allows the removal of the grease

Battery Cable Size For Outboard Models

IMPORTANT: Only use copper battery cables. Do not use aluminum cables

for any outboard marine installations.

• If longer battery cables are required, the wire gauge size must increase. See

chart following for correct wire gauge size.

• DTS L models are equipped with 3.7 m (12 ft.) cables. DTS XL and XXL

models are not shipped with battery cables.

Notes

_______________________